M.Soniks 4 Dash ESC

M.Soniks 4 Dash ESC

Mount the M.sonik-4 as far as is possible away from the receiver, using double-sided
tape or Velcro. Keep the thick power wires away from the antenna and other thin wires to
avoid interference problems. The antenna should come straight out of the receiver into
the antenna tube and up and out of the model. Do not attempt to use any part of the
model as an antenna! The ESC should be positioned to allow cooling air to pass over the
heatsink, this reduces the risk of over-temperature shutdown. Make sure your motor is
fitted with 2 motor capacitors (0.1uF) - one from the negative terminal to the can and one
from the positive terminal to the can.
Receiver Connections
The servo lead on the ESC is wired for all manufacturers in the chart except Airtronics.
For Airtronics receivers you need to swap the red and black wires in the plug.
If removing receiver wires from factory-fitted plug, make a note of the positions of each
colour. To change the wires, lift small plastic retaining tab that holds each wire in place
and remove each wire in turn. Before refitting, please ensure that each wire is in line with
the adapter plug opening. Push each wire in until the plastic retaining tab snaps into
position. On some receiver plugs, the flange fitted may require removal in order to fit into
the receiver. M.sonik-4 ESCs are fitted with a 1.2A BEC unless otherwise stated.
Battery Connections

Black = Battery -ve / = Battery +ve / = Motor +ve / = Motor -ve