Futaba T14SG Combo M2 R7008SB with Tx battery and Charger

Futaba T14SG - Combo with R7008SB Receiver (Mode 2) P-CB14SG/L


Futaba's new T14SG radio system is the perfect radio for any pilot looking for a feature packed radio offering amazing flexibility and upgradability, and of course comes complete with built-in telemetry, being supplied with the 8/18 channel R7008SB receiver. Able to transmit on Futaba's FHSS, FASST and FASSTest transmission systems, the T14SG allows the use of small, light and low cost FHSS receivers as well as FTR (Futaba Transmitter Ready) models, whilst also enabling owners of large complicated and expensive aircraft and helicopters to utilise the ultimate transmission system for reliability and interference rejection, Futaba's FASST system, those requiring telemetry having the further option of FASSTest, FASST expanded system telemetry. Programming is made easier than ever with rotary dial along with integrated switches to quickly select or exit programs etc, whilst the vibration warning alert function adds increased safety/security in flight and even an S-Bus servo programming function is included. The included 6.0v 1700mAh Tx battery will give around 4 hours flying - more than enough for most pilots.

Main Features:
• 14 Channels
• FHSS/FASST/FASSTest Transmission Modes
• Aircraft/Helicopter/Glider Modes
• Telemetry
• Comprehensive Mixing
• 30 Model Memory (Unlimited with optional SD Card)
• Updatable Software
• Left and Right Sliders

About the 14SG:
Channels: 12 proportional, 2 switched
Compatible with FASSTest, FASST and S-FHSS protocols
FASSTest telemetry compatible with Futaba telemetry sensors (sold separately)
Free user-updatable software
30-model memory
10-character user naming
10-character model naming
Airplane, helicopter and glider programming
Large, 1.75 x 3 in backlit LCD screen with 128 x 64 resolution
SensorTouch programming
Compatible with secure digital memory cards for external storage of model setups and software updates (32MB-2GB or HC (High-Capacity) 4GB-32GB)
Left and right assignable slider switches
Two assignable rotary knobs
Six assignable three-position switches
One assignable momentary two-position switch
One assignable two-position switch
Comfortable rubber grips on the sides and back
Wide top switch spacing
Adjustable stick tension
Dual ball bearing gimbals
4 vibration warning types
Home/Exit; User Menu/Servo Monitor buttons
Audio earphone jack (for telemetry alarms)
6V 1800mAh NiMH battery pack
User stick calibration
Trainer system
Servo speed adjust
5 programmable mixes
V-tail, Ailvator, winglet, motor mixing
Trim mix
Logic switch (condition switch only)
Internal programmer for S.Bus servos
User menu
Servo monitor (neutral and moving tests)
2 count up/countdown timers
Integral timer
Model timer
Quick model select
spacer Airplane Features
7 different wing types
3 different tail types
2 different rudder types
Flap setting menu
Differential ailerons
Aileron to camber flap mixing
Aileron to brake flap mixing
Aileron to rudder mixing
Rudder to aileron mixing
Rudder to elevator mixing
Camber mixing
Elevator to camber mixing
Camber flap to elevator mixing
Snap roll mixing
Airbrake mixing
V-Tail mixing
Ailvator
Winglet
Motor mixing
Fuel mixture mixing
Gyro mixing
Throttle curve (5-point)
Pitch curve (5-point)
Idle down
spacer Helicopter Features
6 swash plate types
Pitch/throttle curves (5-point)
Throttle hold
Swash mix
Throttle mix
Pitch to rudder mixing
Fuel mixture
Gyro (Flybarless support)
Governor (700-3500 rpm)
Hover pitch
Hover throttle
High/low pitch
Swash AFR
Swash setting (mixing rate, linkage compensation, speed compensation)
Swash ring (electronic)
Throttle cut
Glider Features
11 different wing types
3 different tail types
2 different rudder types
Flap setting menu
Differential ailerons
Aileron to camber flap mixing
Aileron to brake flap mixing
Aileron to rudder mixing
Rudder to aileron mixing
Rudder to elevator mixing
Camber mixing
Elevator to camber mixing
Camber flap to elevator mixing
Butterfly mixing
Butterfly to elevator mixing